PLASCO INC.

2829 SO. RODEO GULCH RD. #6
PLASCO DATA SHEET
SOQUEL, CA., 95073
TYPICAL PROPERTIES
831-464-1111       831-464-1100 (FAX)

 

MATERIAL:  TAP 000LS
GENERIC:  ACTL/02%SI
 
 

ASTM TEST METHODS VALUE
SPECIFIC GRAVITY: D-792  g/cm3 1.42
WATER ABSORPTION: D-570  24hrs % 0.25
MOLD SHRINK FLOW: D-955  in/in .017
MOLD SHRINK TRANS: D-955  in/in .022
TENSILE STRENGTH: D-638   psi  9,500
TENSILE ELONGATION: D-638  %
FLEXURAL STRENGTH: D-790  psi
FLEXURAL MODULUS: D-790   psi 410,000
COMPRESSIVE STRENGTH: D-695  psi
IZOD NOTCHED: D-256  ft-lb/in 1.2
IZOD UNNOTCHED: D-256   ft-lb/in
HARDNESS: D-785


CO. LINEAR THERM.EXP: D-696  10(-5) "/"F 5.4
THERMAL COND: C-177 btu-ft2/hr"F
DEFORMATION UNDER LOAD: D-621   %
HDT 66: D-648  F 240
HDT 264: D-648  F
FLAMMABILITY: UL  SUBJECT 94 HB


5 KV DECAY RATE: MIL-B-81705B
SURFACE RESISTIVITY: ohm/sq.
VOLUME RESISTIVITY: ohm-cm.


WEAR FACTOR: 10(-10)in3min/ft/lb/hr 20
STATIC FRICTION: 40psi 0.08
DYNAMIC FRICTION: 40psi  50fpm 0.11
LPV 10FPM: psi  fpm  7,000
LPV 100FPM: psi  fpm 12,000


MELT TEMP: F 410
MOLD TEMP: F 225
CYLINDER TEMPS: F 350-425
DRYING TEMP: F 200
DRYING TIME: HRS
This information is based on our experience to date and we believe it to be reliable. It is intended only as a guide for use at your discretion & risk. We cannot guarantee favorable results and assume no liability in connection with its use. None of this information is to be taken as a license to operate under, or a recommendation to infringe, any patents.

Return to Lubricated Compounds